.jpg)
hammer crusher
Application: It can be used to crush medium hardness or crisp materials in mine, cement, coal, metallurgy, building material, road industries. The discharging size can be adjusted according to the specific requirement.
Suitable material: It can crush medium hardness and weak corrosive material with compression strength less than 100Mpa. The water content should be less than 15%. The material can be coal, salt, plaster, brick, limestone etc.
立即訂購
產(chǎn)品特點
1. Easy structure, high broke ratio and productivity.
2. It has dry and wet crushing modes.
3. It can be used in crush production line, sand production line and also can replace the cone crusher in sand choosing production line.
工作原理
Working principles: the motor drives the rotor to rotate at high speed in the crushing chamber. The materials fed from the upper part of the crusher, are impacted, sheared and crushed by the high speed rotating hammer. At the lower part, the screening plates are equipped, which allow the materials less then the sieve discharge; and the materials over the sieve are left on the screening plate to be continuously impacted and crushed by the hammer, finally it’s discharged.
技術(shù)參數(shù)
|
Specification model |
Speed |
Feed particle size |
Grain size |
Yield |
Weight |
Power |
Dimensions |
|
PC-400×300 |
1450 |
≤100 |
10 |
3-10 |
0.8 |
11 |
812×9827×85 |
|
PC-500×350 |
1250 |
≤100 |
15 |
5-15 |
1.2 |
18.5 |
1200×1114×1114 |
|
PC-600×400 |
1000 |
≤220 |
15 |
5-25 |
1.5 |
22 |
1055×1022×1122 |
|
PC-800×600 |
980 |
≤350 |
15 |
10-50 |
3.1 |
55 |
1360×1330×1020 |
|
PC-800×800 |
980 |
≤350 |
15 |
10-60 |
3.5 |
75 |
1440×1740×1101 |
應用案例
其他產(chǎn)品
-
special crusher for whole piece residual anode carbon -
roll crusher -
Hydraulic cune crusher -
impact crusher -
PFL Series Vertical Complex Crusher