.jpg)
-
網站資料更新中..
special crusher for whole piece residual anode carbon
Most enterprises in carbon industry adopt the 500 tons oil crusher. When it’s used for crush the residual anode carbon, the time for crushing one piece is longer (about 2~3 minutes). In addition, the oil pipes of hydraulic system are more complex making the sealing conditions not satisfactory and oil leakage occurs often. So the frequent maintenance is required resulting in the decreased efficiency and extremely high cost. The technicians of our company visited many customers and carried out the detailed study and analysis of the structure of large jaw crusher, and after repeated test, they have successfully developed the special crusher for whole piece residual anode carbon and obtained the patent certificate No: PUM114194
立即訂購
產品特點
2. The oiling pump will be used for bearing lubrication, which is easy and convenient.
Main structureDwg. 1: Frame
Dwg. 2: Fix jaw plate
Dwg. 5: Movable jaw protection plate
Dwg.6: Flywheel
Dwg.7: Movable jaw
Dwg.8: Eccentric shaft 8
Dwg.9: Thrust plate
This crusher is specially used for the whole piece residual anode carbon, also applied for the rough & middle crushing of various ores or stones with compressive strength less than 250Mps in mining, construction, road and chemical industries etc. This is patented product indepentently researched and developed by our company.
工作原理
1. The eccentric shaft driven by the main motor via the triangle belt makes the movable jaw doing the periodic reciprocating motion in order to impact and crush the materials, which will be discharged by the weight itselves.
2. The rack of the crusher is welded by the steel plates. The fix jaw plate is installed on the front, and the side walls are equipped with liners. The movable jaw is welded also by the steel plate on which there is toothed plate pressed by wedge iron. When there is wear on the toothed plate ( usually the lower end is wore more), it can be inverted to be used continually.
3.The front part of the thrust plate is supported on the elbow plate of lower end of the movable jaw, and its bear part is installed on the elbow plate of bear rack. The thrust plate which moves with the movable jaw, will protect the foreign matter from entering in the crushing chamber. That means it can break itself to stop the load in order to avoid the damage on other parts. The shimsets equipped on the bear of the thrust plate are used for adjusting the discharge port.
4.The pull rod (13) and the spring (12) having the locking function will tension the movable jaw and prevent the thrust plate from falling off in order to ensure the normal running of the crusher.
技術參數
應用案例
-
網站資料更新中...
其他產品
-
roll crusher -
hammer crusher -
Hydraulic cune crusher -
impact crusher -
PFL Series Vertical Complex Crusher